![]() Module configuration information is stored in /etc/modprobe.d/ndiswrapper If you have a 64 bit Ubuntu, the procedure is slightly more complicated for ndiswrapper.ĭevice 148f:2570 present (alternative driver: rt2500usb) If it's any consolation Netgear (PCI card) work without any configuration. Stop at the ndiswrapper -l if it doesn't show what you expect though! I have never used this - but I would be tempted to tentatively!!! try This sounds slightly different to sudo ndiswrapper -m ![]() mi write module install configuration for all devices ma write module alias configuration for all devices a devid driver use installed 'driver' for 'devid' (dangerous) i inffile install driver described by 'inffile' Note that interface names (ath0, eth0, wifi0.) seem to be very variable. ![]() # Next 4 lines are for disconnected ethernet My /etc/network/interfaces file reads (ignore the =):. If you prefix a command with sudo (and enter your password) it allows you root access to enable you to write etc to system files. I don't profess to understand what they mean. To answer your question, I know how to enter sudo commands as long as they are specified in full. So one step forward and two steps backward! ![]() So far I haven't been able to find out how to start the network. (with the correct SSID and key of course) I've used the command 'sudo ndiswrapper -m' (which I believe associates an alias for startup?) and get the response 'module configuration already contains alias direction'.įile '/etc/network/interfaces' contains the following. However, when I boot up, it doesn't search for any networks. using the same driver as I use on XP for that device.Īs far as I can tell, it has installed successfully, as I can see the driver associated with the hardware. Axisofevil - I've spent most of today trying to get it to work from instructions at. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |